![]() ![]() ![]() I do not know which ActiveX you are using, although is fair to suppose is CimQuest one. These values will force the next restart of the PLC to happen with the desired mode. If you use one among LSS, SSS, Syswin or CX Programmer, it is easy to find and modify this area, alternatively you can write the DM6600 with one of the following values: 200 for Program, 201 for Monitor and 202 for Run. The startup mode of the PLC can be defined by modifying a special area called PC Setup area. PROGRAM mode: the program execution stops, you can change areas and force/unforce bits. MONITOR mode: the program runs normally, anyway you can change all the areas above mentioned and force/unforce bits RUN mode: the program runs normally, but you couldn't change any memory area, be it DM, AR, HR and so on, nor force/unforce single bits Regardless of which software are you using to communicate with your plc, the Omron C-series got 3 distinct modes:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |